- +91 98189 66288
- info.gogiaplastics@gmail.com
Designed to provide Enhanced, Dependable road Guidance to motorists in bad weather conditions, Made out of strong ABS Molded body with Polycarbonate/PMMA (Acrylic) Micro Prismatic Reflectors ultrasonically welded on the moulded ABS body, Much Better than glass beads markers. These are visible from long distances These are installed with Epoxy – Resin basa adhesive or Special Hot Melt Bitumen Adhesive avoiding nails etc. which can have a harmful effect on the road. Meets or Exceeds ASTM D – 4280 / MORTH Standards.
The right choice for Road Stud Marker fixing is the HOT BIT Marker Adhesive. This Adhesive is a hot-applied Bituminous Material which, when properly used and applied,bonds markers and reflectors to both asphalt and concrete pavement surfaces. The adhesive is supplied as an easy to use Single Component material which is easily melted and poured onto pavement surfaces. Since its a hot melt composition, the adhesive sets up on cooling and is ready for traffic in almost 5 minutes. Heating can be performed in either directly or indirectly heated melting units. The achesive contains no rubber polymers which can degrade at application temperature.
Epoxy + Resin + Hardner + Silica
Road Studs can also be fixed by using Epoxy Resin & Hardner in proper ratio in a container. Silla is usually added for quick fixing of the stud on to the road.
8/8 D.B. Gupta Road, Gogia House, Ground Floor Pahar Ganj, New Delhi – 110055 (India)
Tel : +91-11- 23582754/23582755
Fax : +91-11-23582755
Mobile :+91-9810015718
Email : amangogia@gmail.com
©2023. Road Star India. All Rights Reserved.